Manual de balanceo de carga PCC

Manual de balanceo de carga PCC para 3 Lineas de Internet de la misma Velocidad

si sigues estos 8 pasos basicos tendra tu balaneco Operando de manera correcta

PASO 1

Nombrando las interfaces

aqui se deben identificar las interfaces que van a usar

/interface ethernet

set [ find default-name=ether1 ] comment=Ether1 name=WAN1

set [ find default-name=ether2 ] comment=Ether2 name=WAN2

set [ find default-name=ether3 ] comment=Ether3 name=WAN3

set [ find default-name=ether5 ] comment=Ether5 name=LAN

Configurando las direeciones IP en cada Interfaz

PASO 2

/ip address

add address=192.168.1.1/24 interface=LAN network=192.168.1.0

add address=192.168.100.2/24 interface=WAN1 network=192.168.100.0

add address=192.168.200.2/24 interface=WAN2 network=192.168.200.0

add address=192.168.250.2/24 interface=WAN3 network=192.168.250.0

PASO 3

Enmascarando las interfaces WAN

/ip firewall nat

add action=masquerade chain=srcnat out-interface=WAN1

add action=masquerade chain=srcnat out-interface=WAN2

add action=masquerade chain=srcnat out-interface=WAN3

PASO 4

creando las rutas

/ip route

add gateway=192.168.100.1 check-gateway=ping distance=1

add gateway=192.168.200.1 check-gateway=ping distance=2

add gateway=192.168.250.1 check-gateway=ping distance=3

Paso 5

Vamos a configurar en el mangle las siguientes lineas sirven para marcar las conexiones nuevas

y que lo que entre por una conexion WAN Salga por la misma.

/ip firewall mangle

add chain=prerouting in-interface=WAN1 connection-state=new new-connection-mark=WAN1_conn action=mark-connection passthrough=yes

add chain=prerouting in-interface=WAN2 connection-state=new new-connection-mark=WAN2_conn action=mark-connection passthrough=yes

add chain=prerouting in-interface=WAN3 connection-state=new new-connection-mark=WAN3_conn action=mark-connection passthrough=yes

add chain=output connection-mark=WAN1_conn new-routing-mark=to_WAN1 action=mark-routing passthrough=yes

add chain=output connection-mark=WAN2_conn new-routing-mark=to_WAN2 action=mark-routing passthrough=yes

add chain=output connection-mark=WAN3_conn new-routing-mark=to_WAN3 action=mark-routing passthrough=yes

Paso 6

Ahora dividiremos las conexiones que ingresan por la interfaz nombrada "LAN" utilizando el clasificador per-connection-classifier

/ip firewall mangle

add chain=prerouting

...